![]() You can add more later, if needed, but I doubt more will be needed. Hopefully, that has been fixed, but a manual configured bridge has never shown any performance problems, at least not since 2010.ĭo not give the VM too much RAM or more than 2 vCPUs to begin. I learned long ago not to use the built-in virtual networking when performance was terrible. If you want more control over the networking of client VMs, you might want to install bridge-utils. How to handle storage can be an enterprise discussion, but those are the easy answers for someone new. so ensure you either mount any needed storage there or provide symbolic links from that area to somewhere with a Unix file system that has sufficient storage available. If it is put on a spinning HDD, then you'll want to use a raw image that is fully pre-allocated, pre-sized, to avoid terrible performance.īy default, libvirt controlled VM storage is placed in /var/lib/libvirt/. If the virtual disk is placed on an SSD, then using qcow2 is fine. Use "reasonable" options for disk controller (SATA is probably the best "sure thing" choice), network controller (Intel PRO/1000) and do a fresh install of Win10. Then use virt-manager to create a fresh VM with 2 vCPUs and 4GB of RAM. Next, load up kvm, libvirt and virt-manager packages. Until that is possible, all virtual machines will be terribly slow. KVM acceleration can be usedUntil you see something like that result, you cannot use KVM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |